Can't run Mol on Titanium, YDL 2.1

[Quentin Mason]

> Still can't run mol.  Just did a new build, with my latest kernel.  Same 
> error:

> Starting in video mode 640*480, depth 32, 0.0 Hz  [offs:0, rb:2560]

0.0Hz ?  640x480 <= did you really select this in molvconfig ?

> -----> Can't open /dev/sheep_net, please check module is present !
> Failed to initialize the sheep-<eth1> device
> ----> Failed to open /dev/dsp - Sound Disabled

Do you have the sheep_net module ?? did it compile correctly / do you have 
support for that type of interface in your kernel ?

> HFS  images/moldisk.i MOL                <read-only>     0 MB
> HFS+ /dev/hda9        Booty              <read-write> 15031 MB
> 
> ***** SIGNAL Segmentation fault in thread main-thread *****
>    si_signo = 11, si_errno 0, si_code 00030001
>    si_addr 0x2a. Last RVEC: 0x0 (0)
>    NIP 10037f68
> cleaning up...
> Terminating threads...
> DONE

Is this MacOS 9.2.2 ? Does it have MacOSX o nthe same partition ?  AFAIK
both have troubles with MOL.  Did you enable altivec in the molrc but not
in the kernel ??  There are many possible problems you could have run
into.  Unfortunately I have not worked on the MOL code so I cannot help
you with that specific error, I am just throwing out ideas.  I am guessing
that "Last RVEC = 0" is a bad altivec pointer... but I really have no
idea.

Good luck,

Q.