mol configuration questions

[Roger Scow]

Okay.  I went ahead and did what you suggested.  I also changed the
available RAM to 200 Mb.  I don't know if that makes any difference.

I'm using an apple trackpad... I don't know what input mapping will make
of that.  May need to borrow a mouse.

Turned off xvideo and changed default monitor settings.

Typed startmol -X and voila.  Got a full screen with the MOL (tux and an
apple) logo.  The little OSX wheel thing was spinning away at the bottom
of the screen.  But that is as far as I got.  

How do you escape when you're already there?

Thanks for your answer, Andreas.

Roger

On Tue, 2004-08-17 at 20:24, Andreas Schwab wrote:
> Roger Scow <rscow@mac.com> writes:
> 
> >> Mac-on-Linux 0.9.69 Copyright (C) 1997-2003 Samuel Rydh
> >> Starting MOL session 1
> >> Unknown processor id (70000202).
> >> Running in PowerPC 750 mode, 96 MB RAM
> >> Timebase: 24.83 MHz, Bus: 99.34 MHz, Clock: 800 MHz
> >> Using USB mouse on /dev/input/mice
> >> OHCI USB controller registered
> >> Could not open '/var/lib/mol/x11.kbd'
> >> Fullscreen video on VT 8.
> >> Could not open '/var/lib/mol/console.kbd'
> >> Video driver(s): [xvideo] [console_video]
> >> 
> >>      640* 480, depth 8,15   { 0.0 } Hz
> >>      800* 600, depth 8,15   { 0.0 } Hz
> >>     1024* 768, depth 8,15,32   { 0.0, 60.0, 70.0 } Hz
> >>     1152* 864, depth 8,15   { 0.0 } Hz
> >>     1280*1024, depth 8,15   { 0.0 } Hz
> >>     1600*1200, depth 8,15   { 0.0 } Hz
> >> 
> >> No video mode match the default one.
> 
> Try disabling xvideo in the config (enable_xvideo: no) and setting the
> default resolution to the configured one (resulution: 1024/768/70).
> 
> Use startmol --keyconfig to configure your keyboard.
> 
> Andreas.