Is there a way to re-run the initial video setup from the installer?

[Rich Frueh]

(I have looked around, and can't seem to do a search that gets me what 
I need)

My story is this:  I have a 7300/200, and I got YDL3.0 to install on 
it, but every time I did, I'd boot up, go into graphical login 
automatically, and get "sync out of range" on my monitor.  I did some 
dinking several times, and re-installed, and finally just told it to 
use 640x480 and the text login.  The installer never found my vid. 
card or monitor type in probing, so I had to select, but I didn't knwo 
which vid card to use, so left it at Generic OF, which I think goes to 
fbdev.

Is there a way to run that portion of the installer again so that I 
can reset that, since I believe I have the ATI 128, or is there 
something else I can do?

Do I need to set any boot variables in BootX before I get into YDL?

Barring the re-running the installer, a working XFree86config for a 
7300/200 would be sweet, along with anything else that would be a good 
bit of info to have with this machine.

Also, where do I go to get to my other two hard drives? (normal MacOS 
HFS+ drives)  Is there a graphical front end to fstab and mnt?

Thanks,
Rich

--
      Just imagine a really neat quote here