[ydl-gen] YDL 4.1 on a G5-1.8-Single
Keith Mitchell
kamitch at cisco.com
Fri Mar 10 09:05:01 MST 2006
Hi,
I cannot seem to get YDL 4.1 to work on a Powermac G5 Single (Powermac
9,1). It installs ok but once I reboot the thing locks up abotu 30
minutes after boot and after a while starts outputting the following
messages:
hda: lost interrupt
mipc_enable_irq timeout
It seems to work fine, however, on a Dual-Proc 2.0 or 2.7 machine.
Furthermore, if I use one of the dual-proc machines to try and compile a
new kernel (a stock kernel... i.e. 2.6.15.6) using the default config
(from arch/powerpc/configs/g5_defconfig) it will not compile. I get the
following error message:
drivers/md/raid6int8.c: In function `raid6_int8_gen_syndrome':
drivers/md/raid6int8.c:185: error: unable to find a register to spill in class `FLOAT_REGS'
drivers/md/raid6int8.c:185: error: this is the insn:
(insn:HI 619 621 640 4 (set (mem:DI (plus:DI (reg/v/f:DI 122 [ p ])
(reg/v:DI 66 ctr [orig:124 d ] [124])) [0 S8 A64])
(reg/v:DI 129 [ wp0 ])) 320 {*movdi_internal64} (nil)
(expr_list:REG_DEAD (reg/v:DI 129 [ wp0 ])
(nil)))
drivers/md/raid6int8.c:185: confused by earlier errors, bailing out
make[2]: *** [drivers/md/raid6int8.o] Error 1
make[1]: *** [drivers/md] Error 2
make: *** [drivers] Error 2
[root at kamitch-lnx linux-2.6.15.6]# gcc --version
gcc (GCC) 3.4.4 20050721 (Yellow Dog 3.4.4-2.ydl.2)
Copyright (C) 2004 Free Software Foundation, Inc.
This is free software; see the source for copying conditions. There is NO
warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.
Has anyone been successful at getting 4.1 up and running on the newer
single 1.8 machines? I had 4.0.91 running without a problem.
More information about the yellowdog-general
mailing list