Subject: Re: Screen Resolution
From: Sam Moore (samiwas@macconnect.com)
Date: Sun Aug 13 2000 - 19:33:04 MDT
Have a look at /etc/X11/XF86Config
especially down at the bottom in the section called "Screen".
That should help.
On 8/13/00 at 2:19 PM, hshere@greendragon.com (Howard Shere) wrote:
>
> This should be a simple question.
>
> I have Linux running. I am at the command line. I remember putting some
> params in the bootx control panel to specify the resolution, but I don't
> remember what those commands are.
>
> How can I tell from the command line what the current res and scan rate are
> set to? I'd rather not have to reboot into MacOS to check the params. There
> must be a way to tell.
>
> I know it is in the x configuration file somewhere, but I don't remember
> where that config file is hiding.
>
> _________________________________________________________________________
> Gridz 1.3 ---- www.gridz.com ---- NetSpace will never be the same again
> _________________________________________________________________________
> Howard Shere | Green Dragon Creations | Water Valley Interchange
> President | 301 N. Main St. | P.O. Box 70
> Software Sculptor | Water Valley, MS 38965 | Water Valley, MS 38965
> | hshere@greendragon.com | hshere@watervalley.net
> | www.greendragon.com | www.watervalley.net
> | 1-662-473-4225 | 1-662-473-9209
>
Sam Moore <smoo@lungta.org>
dba Windhorse Studio * Maps & Information Design
Personal: http://www.lungta.org (not ready yet)
For the clan: http://smhtf.lungta.org
Work: http://www.ewcreative.com
"Good and bad, happy and sad, all thoughts vanish into
emptiness like the imprint of a bird in the sky."
This archive was generated by hypermail 2a24 : Sun Aug 13 2000 - 19:36:09 MDT