Subject: Re: Mol Installation/Running Problems!
From: John M. Wright (jmw@chem.ucsd.edu)
Date: Sun May 07 2000 - 18:26:42 MDT
Dave,
1) Are you running as root when you type "startmol"?
2) Did you copy the new-world rom file from your system folder,
run strip_nwrom on it, and install it in the right place?
3) Did you make sure the partition you want to run MOL on is
_unmounted_ under linux when you started MOL?
On Date: Sun, 07 May 2000 16:24:52 -0600
Dave Lesovoy <col22@earthlink.net> wrote:
-jmw-
> To: mol-general@lists.maconlinux.org
> Subject: Mol Installation/Running Problems!
>
> Ok, I have LinuxPPC 2000 with Kernel 2.2.15pre3. I have a Power Mac
> 8500/132 with a 233mhz g3 daughter card. I boot into linux using BootX
> 1.2b3. I am running Mac OS 9.0.
> I have a 320MB HD with another copy of Mac OS 9 on it specifically
> created for Mac On Linux. Its the HD I want MOL to use. I have the
> mountpoint and everything set up, I can read and write it in linux and
> all (and auto-mount it whenever linux boots up). After I did that, I
> downloaded the newest version of MOL (0.9.41-1) into my root directory
> (/) under the root user. I tried to install it in terminal mode (rpm -i
> mol-0.9.41-1.ppc.rpm) but it said it couldn't open it. So I used the
> gnome file browser to open it, and I double clicked install. I think it
> was installed. I then goto the terminal, and type startmol. It starts up
> fine, checks my System.map file, likes it, and gets ready to patch my
> kernel, then it gets hit by indigestion. It says it failed to patch my
> kernel. I can't figure out what my problem is. If anyone can help me,
> I'd appreciate it.
>
> -Dave
> --
> __
> "Do or do not. There is no try."
> -Yoda
>
>
>
> --pladjlpdldifgmchelcg--
>
This archive was generated by hypermail 2a24 : Sun May 07 2000 - 18:26:18 MDT