Subject: Small Problem...
From: Brian Foddy (bkfoddy@soc.nwa.com)
Date: Wed May 24 2000 - 11:06:58 MDT
I have an minor but annoying problem with the later versions
of mol (0.9.41 -.44).
Every time I start MOL, it resets the Appletalk network device
to the printer port. Every time I change it to Ethernet, but
it never saves it for the next session. In versions
before 0.9.41, it would only reset when I'd install a new
version, but would then permanently save the setting.
Once I change the setting, it keeps working for the session,
(except for the already known networking packets issues).
I run MOL as root, by startmol, so it should have write permissions to
any file it wants.
I can't think of any other config changes that would have
caused this problem. Ideas?
Brian
This archive was generated by hypermail 2a24 : Wed May 24 2000 - 11:17:11 MDT