Subject: Re: Small Problem...
From: Daniel E. Sabath (dsabath@u.washington.edu)
Date: Wed May 24 2000 - 11:35:31 MDT
On 5/24/00 10:06 AM, Brian Foddy at bkfoddy@soc.nwa.com wrote:
> I have an minor but annoying problem with the later versions
> of mol (0.9.41 -.44).
>
> Every time I start MOL, it resets the Appletalk network device
> to the printer port. Every time I change it to Ethernet, but
> it never saves it for the next session. In versions
> before 0.9.41, it would only reset when I'd install a new
> version, but would then permanently save the setting.
> Once I change the setting, it keeps working for the session,
> (except for the already known networking packets issues).
>
> I run MOL as root, by startmol, so it should have write permissions to
> any file it wants.
>
> I can't think of any other config changes that would have
> caused this problem. Ideas?
This always happened to me with 0.9.41 as well. Very annoying.
Dan
-- Daniel E. Sabath, M.D., Ph.D. Department of Laboratory Medicine, University of Washington Box 357110 Seattle, WA 98195-7110 Office: 206-598-6833 Lab: 206-543-9032 Fax: 206-598-6189 http://depts.washington.edu/labweb/Faculty/Sabath.Dan.html
This archive was generated by hypermail 2a24 : Wed May 24 2000 - 11:34:39 MDT