Subject: Re: Small Problem...
From: David Block (dblock@gene.pbi.nrc.ca)
Date: Wed May 24 2000 - 11:44:59 MDT
I have my Mac set up to open the TCP/IP panel on startup. It then
realizes that something is wrong, and corrects it. I only have this type
of problem when switching between native Mac (Madden 2000) and mol
(productivity).
HTH,
-Dave
On Wed, 24 May 2000, Brian Foddy wrote:
> I have an minor but annoying problem with the later versions
> of mol (0.9.41 -.44).
>
> Every time I start MOL, it resets the Appletalk network device
> to the printer port. Every time I change it to Ethernet, but
> it never saves it for the next session. In versions
> before 0.9.41, it would only reset when I'd install a new
> version, but would then permanently save the setting.
> Once I change the setting, it keeps working for the session,
> (except for the already known networking packets issues).
>
> I run MOL as root, by startmol, so it should have write permissions to
> any file it wants.
>
> I can't think of any other config changes that would have
> caused this problem. Ideas?
>
> Brian
>
This archive was generated by hypermail 2a24 : Wed May 24 2000 - 11:44:29 MDT