[powerstation-owners] Upgrading memory

[Trujillo, Lorrie - AES]

Please remove me from this emailing list.

Thank you,

Lorrie A. Trujillo
Sr. Buyer
ITT Advanced Engineering & Science
5901 Indian School Rd NE
Albuquerque, NM 87110
Phone:  505 938-6408
Fax:  505 938-6410

-----Original Message-----
From: powerstation-owners-bounces at lists.terrasoftsolutions.com [mailto:powerstation-owners-bounces at lists.terrasoftsolutions.com] On Behalf Of Mel Gorman
Sent: Friday, November 28, 2008 4:20 AM
To: powerstation-owners at lists.terrasoftsolutions.com
Subject: [powerstation-owners] Upgrading memory

This is an embarassingly stupid question but how is the memory meant to
be upgraded in these machines? I replaced the two old DIMMs with two of
what should be similar type;

2 x 2GB 667MHz DDR2 P2-5300 ECC REG with Parity CL5, 240 pin Dual rank.

On boot-up, it says

JS2XBlade Starting
 Build Date = Jul 22 2008 17:16:18
 FW Version = JX-1.7.0-3
 Check ROM  = OK
 Press "s" to enter Open Firmware.

U4 DDR2 memory controller setup V2.1
------------------------------------
> detected board              : BIMINI
> detected DIMM configuration :
  [ERROR -> wrong DIMM organisation in bank 0]
  [ERROR -> wrong DIMM organisation in bank 0]
> initialization failure.

I haven't been able to find a motherboard manual to determine if anything
else is required for an upgrade, what the correct type of memory is or if
there is a specific part required.

Thanks

--
Mel Gorman
Part-time Phd Student                          Linux Technology Center
University of Limerick                         IBM Dublin Software Lab
_______________________________________________
powerstation-owners mailing list
powerstation-owners at lists.terrasoftsolutions.com
http://lists.fixstars.com/mailman/listinfo/powerstation-owners

This e-mail and any files transmitted with it may be proprietary and are intended solely for the use of the individual or entity to whom they are addressed. If you have received this e-mail in error please notify the sender.
Please note that any views or opinions presented in this e-mail are solely those of the author and do not necessarily represent those of ITT Corporation. The recipient should check this e-mail and any attachments for the presence of viruses. ITT accepts no liability for any damage caused by any virus transmitted by this e-mail.