YDL doesn't recognize scsi device
Robert Serphillips
yellowdog-general@lists.terrasoftsolutions.com
Fri Jan 10 12:24:01 2003
Use the 2.4.18 or newer kernel. It has a longer adjustable delay after
the scsi bus reset to allow for slower devices to respond.
-Rob
On Fri, 10 Jan 2003 10:51:48 -0600 (CST)
"Jerome.Busenitz" <busenitz@bama.ua.edu> wrote:
> I am running a standard installation of YDL 2.1 on a 4400/200.
>
> I have just attached a UMAX Astra 1220S scanner with ID 5 to the
> built-in
> SCSI port. It is not recognized. During bootup, the following is
> reported:
> SCSI subsystem driver Revision: 1.00
> scsi0 : SCSI host adapter emulation for IDE ATAPI devices
> scsi1 : MESH
> mesh: target 5 aborted
>
> If I instead boot up under Mac OS 8.5, the scanner is recognized
> as expected at ID 5 on SCSI bus 0.
>
> Any assistance on why the scanner is not being recognized under
> YDL and
> how to correct it would be greatly appreciated.
>
> Best regards,
> Jerry Busenitz
> University of Alabama
>
> _______________________________________________
> yellowdog-general mailing list
> yellowdog-general@lists.terrasoftsolutions.com
> http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-general
>