CUPS no route to host

[yvon]

Hey all,

i have a LaserWritter IIg attached to the ethernet port of my ppc 9500
running ydl 2.3 and cups-1.1.14-10b when i try to print a test page i
have the following message on http://localhost:631/printers :

here is my setup :
Device URI: socket://192.168.0.254:9100/

[root@localhost yvon]# route -F
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
192.168.0.0     *               255.255.255.0   U     0      0        0
eth0
127.0.0.0       *               255.0.0.0       U     0      0        0
lo
[root@localhost yvon]# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:05:02:EC:D8:47  
          inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 
          RX bytes:0 (0.0 b)  TX bytes:1770 (1.7 Kb)

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:2914 errors:0 dropped:0 overruns:0 frame:0
          TX packets:2914 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 
          RX bytes:534745 (522.2 Kb)  TX bytes:534745 (522.2 Kb)


I do have another printer on this machine, it is an Epson Stylus Color
500 when i try to print test i do have a message from cups saying x%
printed but i ear nothing coming from the printer. I'm sure ttyS1 is
working because i'm using the printer port, from time to time, for pilot
sync and it works well.

the setup :
Device URI: serial:/dev/ttyS1?baud=1200+bits=8+parity=none+flow=none

-- 
Yvon Thoraval