local network using ethernet and modem

[yvon]

I've a dialup connection using an external modem. I'd like to allow
other computers to use this connection thru ethernet (builtin over a
ppc9500) , I've followed carrefully the advice given onto the yellowdog
web site. However this don't work here.

Then i wonder if my builtin isn't missconfigured because when i try to
ping another machine over this very small (2 computers) network i get
"host unreachable". I'm sure the harware connection works because i'm
able to connect both computers under AppleTalk either under macos or
linux (ysing netatlk in this case).

here is my config :
[root@baladeur yvon]# route -F
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
192.168.0.0     *               255.255.255.0   U     0      0        0
eth0
127.0.0.0       *               255.0.0.0       U     0      0        0
lo

[root@baladeur yvon]# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:05:02:EC:D8:47  
          inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
          EtherTalk Phase 2 addr:65280/81
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:51 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 
          RX bytes:0 (0.0 b)  TX bytes:2578 (2.5 Kb)

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          EtherTalk Phase 2 addr:0/0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:5057 errors:0 dropped:0 overruns:0 frame:0
          TX packets:5057 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 
          RX bytes:941383 (919.3 Kb)  TX bytes:941383 (919.3 Kb)

[root@baladeur yvon]# ping 192.168.0.2
PING 192.168.0.2 (192.168.0.2) from 192.168.0.1 : 56(84) bytes of data.
>From 192.168.0.1: Destination Host Unreachable


-- 
Yvon Thoraval