Kernel panic after IDE init when booting 3.0 CD

[yellowdog-newbie@lists.terrasoftsolutions.com]

THIS IS SCTRICTLY a guess. But perhaps partitioning of the drive might be
necessary???
----- Original Message -----
From: "Reid Beels" <reidab@mac.com>
To: <yellowdog-newbie@lists.terrasoftsolutions.com>;
<yellowdog-general@lists.terrasoftsolutions.com>
Sent: Friday, May 02, 2003 9:42 PM
Subject: Kernel panic after IDE init when booting 3.0 CD


> I'm attempting to install YDL 3.0 on a 450 G4 and when I attempt to
> boot the system from the CD I receive a kernel panic after the IDE
> initialization.   This same thing has happened before using a 2.3 CD
> and I had hoped that 3.0 would resolve the issue. The messages near the
> panic are as follows:
>
> Uniform Multi-Platform E-IDE driver Revision: 6.31
> ide: Assuming 33MHz system bus speed for PIO modes; override with
> idebus=xx
> ide0: Foung Apple KeyLargo ATA-4 controller, bus ID 2
> ide1: Foung Apple KeyLargo ATA-3 controller, bus ID 0
> ide2: Foung Apple KeyLargo ATA-4 controller, bus ID 1
> Probing IDE interface ide0...
> hda: IBM-DPTA-371020, ATA DISK drive
> hdb: MAXTOR 4K040H2, ATA DISK drive
> Probing IDE interface ide1...
> hdc: MATSHITADVD-ROM SR-8585, ATAPT CD/DVD-ROM drive
> Probing IDE interface ide2...
> ide0 at 0xf1368000-0xf1368007,0xf1368160 on irq 19
> ide1 at 0xf136c000-0xf136c007,0xf136c160 on irq 20
> hda: Enable Ultra DMA 4
> blk: que c02d7778, I/O limit 4095Mb (mask 0xffffffff)
> Oops: Exception in kernel mode, sig: 4
>
> After this there come the barrage of hex values and such that tend to
> accompany kernel panics.  If anyone would find these useful in
> diagnosing this problem, let me know and i can post them.  Thank you,
> Reid Beels
>
> _______________________________________________
> yellowdog-newbie mailing list
> yellowdog-newbie@lists.terrasoftsolutions.com
> http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-newbie
>