ethernet card: working/not working

[Ian Loves Linux]

turn on the fire wall? why?

the ip is automatic setup for dhcp.

yes eth0 is active during boot.

no i do not have my own hostname

yes the network config app sees the card (see below The hardware is a 
(UniNorth 2 GMAC (Sun GEM)) )

thanks,
ian

> Turn on that firewall!
> Did you check that your IP address is manual or automatic and which
> Pop-up using are using such as DHCP or something else??
>
> Is eth0 active at boot or do you have to turn it on?
> Do you have your own hostname?
>
> Does the Network Config app see your ethernet card?
>
> On Mon, 2004-08-02 at 21:43, linux@empireofstyle.com wrote:
>> hello list,
>>
>> i finally got x working on my powerbook and it boots into kde or gnome
>> without a problem.
>>
>> however. now my ethernet connection doesnt seem to work.
>>
>> previously when x failed to launch and i was in terminal only mode i 
>> could
>> use it. i did a yum update yum and yum upgrade without any problem.
>>
>> however. now that i boot into gnome i cant call up a web site.
>> i can however 192.168.1.1 to my router.
>>
>> ive gone into the Network Device Control and looked at the settings.
>> Everything seems to be fine. It can deactivate and activate without a
>> problem.
>>
>> The hardware is a (UniNorth 2 GMAC (Sun GEM))
>>
>> Ive aslo checked the Security Settings panel and turned of any 
>> firewall
>> but no luck...
>>
>> Any ideas?
>>
>> Thanks,
>> Ian
>>
>>
>> _______________________________________________
>> yellowdog-newbie mailing list
>> yellowdog-newbie@lists.terrasoftsolutions.com
>> http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-newbie
>
> _______________________________________________
> yellowdog-newbie mailing list
> yellowdog-newbie@lists.terrasoftsolutions.com
> http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-newbie
>