Subject: Re: Device has been modified + pending input events
From: Samuel Rydh (samuel@ibrium.se)
Date: Wed Oct 25 2000 - 14:32:45 MDT
On Wed, Oct 25, 2000 at 09:44:57PM +0200, Jean-Jacques Levy wrote:
>
> Mol 9.52 runs perfectly with my PB G3 1999 Lombard + 2.2.17pre20-ben3.
> THANKS AGAIN! However 2 problems:
>
> - when I save a session with F12, I cannot immediately restart with
> startmol and get the message:
> *** Device '/dev/hda6' has been modified since the session was saved!
> *** Can't restore a session if one of the volumes has been modified.
>
Are you using the /etc/mol.sh script? If so, then the exchange volume
is automatically remounted r/w when mol exits. Note that MOL considers
any volume mounted r/w since the last session as dirty (MOL can only
check if a moule has been mounted, not if it was actually modified).
I don't recommend using exchange volumes between MOL and MacOS. A *MUCH*
better solution is using netatalk and a shared net volume. This
works very well and should not be very difficult to configure.
Regards,
/Samuel
----------------------------------------------------------
E-mail <samuel@ibrium.se> WWW: <http://www.ibrium.se>
Phone/fax: (home) +46 8 4418431, (work) +46 8 7908470
----------------------------------------------------------
This archive was generated by hypermail 2a24 : Wed Oct 25 2000 - 14:40:08 MDT