Subject: MOL 0.9.60-49
From: Alfred Mutscheller (Mutscheller@t-online.de )
Date: Mon Nov 12 2001 - 14:09:46 MST
Hi,
I am using SuSE Linux 7.1 on a Power Mac G3.
I got mol-0.9.60-49 and the km_mol-0.9.60-49 modules and installed these
two
archives. Following the compilation instruction ( make clean, make, make
install)
I rebuild MOL.
If I now start mol I get the following response.
MacG3:/usr/lib/mol/bin # startmol
====================================================================
No mol-0.9.60 kernel modules corresponding to the running
2.4.2 kernel were found ('startmol --list' displays
installed version). Recompile the mol kernel modules (recommended)
or try starting MOL using the '-a' switch. The '-a' flag can be
made default by adding 'allow_kver_mismatch: yes' to /etc/molrc.
====================================================================
MacG3:/usr/lib/mol/bin # startmol -a
====================================================================
No kernel module suitable for this kernel was found. The MOL
kernel modules must be recompiled (refer to www.maconlinux.org
for instructions). The command 'startmol --list' can be used
to display installed kernel modules.
====================================================================
MacG3:/usr/lib/mol/bin # startmol --list
---------------------------------
Installed modules:
---------------------------------
2.2.18/misc
---------------------------------
Running kernel: 2.4.2
---------------------------------
-noav = No AltiVec
-smp = Multiprocessor Kernel
Why are the modules for the 2.2.18 kernel loaded and not the ones for the
2.4.2 kernel ?
Alfred
This archive was generated by hypermail 2a24 : Mon Nov 12 2001 - 13:18:51 MST