Yamaha CRW 2100
Åke Svensson
yellowdog-general@lists.terrasoftsolutions.com
Fri Apr 5 01:21:00 2002
Hi Robert!
I suppose you checked the termination on the CRW? If in between id 0 and the
last device in the SCSI chain it should be off, otherwise you should jumper
it to on. You could also try to change its SCSI id. There is a bit voodoo
involved with SCSI.
Regards,
Ake Svensson
> Från: Robert Serphillips <rserphillips@austin.rr.com>
> Organisation: Home
> Svara till: yellowdog-general@lists.terrasoftsolutions.com
> Datum: Fri, 5 Apr 2002 00:29:17 -0600
> Till: yellowdog-general@lists.terrasoftsolutions.com
> Ämne: Re: Yamaha CRW 2100
>
> Here is the dmesg output. The drive in question is on id 1
>
> mesh: target 0 synchronous at 10.0 MB/s
> Vendor: WDIGTL Model: WDE9150 ULTRA3 Rev: 1.30
> Type: Direct-Access ANSI SCSI revision: 03
>
> mesh: target 1 aborted <-- hmm.. Why is that
>
> mesh: target 3 synchronous at 10.0 MB/s
> Vendor: SEAGATE Model: ST34502LW Rev: 7503
> Type: Direct-Access ANSI SCSI revision: 02
> scsi1 : 53C94
>
> On Thu, 4 Apr 2002 23:46:34 -0600
> Robert Serphillips <rserphillips@austin.rr.com> wrote:
>
>> I just swapped out the stock cdrom with a Yamaha CRW2100, firmware 1.0n.
>> There's no mention of it in the dmesg output. From what I can tell this =
drive
>> should be supported. Why is it not seeing the drive? Works fine under Ma=
cOS
>>
>> Machine is an 8500
>> YDL 2.0
>> Kernel 2.4.18-ben0 (tried 2.4.10 off the cd)
>> _______________________________________________
>> yellowdog-general mailing list
>> yellowdog-general@lists.terrasoftsolutions.com
>> http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-general
> _______________________________________________
> yellowdog-general mailing list
> yellowdog-general@lists.terrasoftsolutions.com
> http://lists.terrasoftsolutions.com/mailman/listinfo/yellowdog-general
>