YDL 3.0 install and Epson C40UX printer

[Stephen Harker]

On Wed, Jul 23, 2003 at 02:51:25PM +0200, mamonbbux wrote:
> Stephen Harker a écrit :
> >I would be interested to hear if 4.2.3 does work for you.
> 
> root@bbux gimp-print-4.2.5]# ./configure \
> --with-gimp \
> --with-escputil \
> --with-foomatic
> ( ... start ... of ... configure ... bla ... bla ... bla ...)
> *** The gimptool script installed by GIMP could not be found
> *** If GIMP was installed in PREFIX, make sure PREFIX/bin is in
> *** your path, or set the GIMPTOOL environment variable to the
> *** full path to gimptool.
> configure: error: Cannot find GIMP libraries: Please run ldconfig as root

I do have gimp and the gimp libraries installed, that may be a
difference.  I read the README's a while back, but I have just been
following the procedure of :

          sh ./configure   (I don't have . in the path)
          make
          make install     (well, sudo make install)

It is good to hear that you have got something to printout.  I am not
sure where the complications.  The gimp related rpm's I have installed
are: 

 rpm -qa | grep gimp
gimp-print-cups-4.2.1-5
gimp-print-utils-4.2.1-5
gimp-1.2.3-9
xsane-gimp-0.84-8
gimp-print-4.2.1-5
gimp-data-extras-1.2.0-6

I would suspect that the gimp-1.2.3-9 may be the one you might need,
it does install a number of libraries in /usr/lib.  It sounds like
some steps forward.

Once I had the gimp-print driver queue set and a test page printed I
then tried printing from applications by selecting the queue.  I have
had no problems with the limited range of applications I have tried on
this printer (mozilla and the shell).

-- 
Stephen Harker                           Stephen.Harker@spme.monash.edu.au
School of Physics and Materials Engineering
Monash University                       http://www.ph.adfa.edu.au/s-harker/
                                 Baloney Baffles brains: Eric Frank Russell