Configuring a 802.11b USB key
bein limited
beinltd at yahoo.com
Thu Aug 31 11:02:02 MDT 2006
Hi,
I have tried to follow the instructions posted by Bill Mueller at
http://www.terrasoftsolutions.com/support/solutions/ydl_4.1/usb-802.11b-key.shtml
and I'm running into some problems (probably because I'm new).
I'm trying this on a G3 imac with YDL 4.1 installed from the disks (I haven't connected to the internet yet for updates, so let me know if that's where my problem is!)
I tried to follow the instructions, but used a more recent driver. I didn't run into problems until the make install. So I went back and got the driver specified in the instructions and tried again. Interestingly, the tar command creates a directory named linux-wlan-ng-0.2.1pre21 not linux-wlan-ng-0.2.1-pre21.
But when I did the make config and selected only the usb driver, it gave me the following:
Linux source directory [usr/src/linux]:
I pressed Enter, but it gave to following message:
Linux source tree /usr/src/linux is incomplete or missing!
See the HOWTO for a list of FTP sites for current kernel sources.
Configuration failed
make: *** [config] Error 1
Could someone clue me in to what I'm missing here, or what would get the config to work?
Thanks,
Carol Bean
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.terrasoftsolutions.com/pipermail/yellowdog-newbie/attachments/20060831/eec16445/attachment.html
More information about the yellowdog-newbie
mailing list